 |
| HR53 Work in progress |
The chassis runs smoothly, though as an 0-4-0, as I've made no provision as yet for pick-ups on the bogie wheels. I have all the parts I need to hand now including the dome which together with the chimney was turned by pals at the Carlisle club. These need a good deal of file work to finish them, nevertheless they're looking the part. When the front splashers are in place they should mask most of the area under the boiler so I don't plan to model any inside motion. A metal fillet will be added inside the cab corners which will help when I round the corners off . The front and rear of the cab will be double-skinned to facilitate glazing.
 |
| HR53 |
The MSC fly wheel much improves the running quality of the chassis. It protrudes into the cab and will run partly inside the backhead though it will have to be reduced in width to fit. There is a circle of rivets behind the smokebox, clearly visible on photos of the prototype. I've left room for them on one of the rings behind the smokebox and plan to use resin transfer rivets from Archer Surface Details to model them. There's an instructional video linked to their website which shows how to make a circle of rivets. I made a trial circle and thought the results were encouraging, the backing to the resin transfer rivets is very fine and won't show behind the smokebox and the rivets themselves seem robust enough for the job. I plan to use these transfers to model the little lines of rivets that surround the window openings too.
No comments:
Post a Comment